Wrench Boat

Wrench Boat

Braid Drain Plug Wrench

$12.99

Braid Drain Plug Wrench . A multi-use tool that will remove all twist-in drain plugs, while also having a built in compartment to hold spare drain plugs or the one you just took out of the boat in addition to being a floating key holder.

Marinetech Products Bent Wrench

$31.99

Marinetech Products Bent Wrench . The only jack plate you can adjust from inside the boat with only one screwThe only jack plate that can be adjusted from inside the boat with only one screw. Patented design has no side hardware to loosen. Just turn the adjustment screw to the desired height, tighten the locking nut, and you are ready to go. Great for bass boats, bay boats, flats, skiff and walleye boats or offshore racers. Rated for 585hp. Vertical lift of 3.5″. Interlocking design provides strength. Anodized aluminum body, aluminum angle, bronze oil-lite bushings, precision stainless steel support rods. Specially designed Bent Wrench allows simple adjustment of manual on-the-water plates.

Wrench

$19.99

Cooper Mears Wrench – Photographic Print

Delta Parts RP52217 – Wrench

$8.77

Wrench

Groco Thru Hull Step Wrench

$64.99

Groco Thru Hull Step Wrench . THT-530 makes the installation of standard GROCO thru-hull fittings possible by a single installer. Slide the thru-hull fitting, flanged end first, over the tool. (It will stop at the proper step.) Tie a length of monofilament to the eye and place it into the already-cut hole in the hull of the boat. Apply caulking to the flange of the fitting, and pull the fitting through the hole and against the hull from inside the boat. Thread the monofilament through the locknut or seacock. With the fitting pulled firmly against the hull, the locknut or the seacock may be screwed onto the fitting. Designed for Groco Thru Hull fittings from 1/2 inch up to 3 inches. This tool may not be compatible with fittings from other sources.